Add paragraph text. Click “Edit Text” to update the font, size and more. To change and reuse text themes, go to Site Styles.
CRESTRON
AMP-2210T
The AMP-2210T is Crestron's 2-channel commercial power amplifier, driving speakers in meeting rooms, boardrooms and conference spaces where clean, reliable level matters.
It delivers 210W per channel at 4 ohm and switches between 4/8 ohm low-impedance and 70/100V constant-voltage loads via terminal block, so it suits either local room speakers or distributed ceiling lines. Per-channel remote power control and auto power-down after 30 minutes of no signal cut idle draw to under 1 W standby.
Its fanless, convection-cooled 1RU chassis runs silently in a rack near sensitive microphones. AVSTEK matches it to speaker loads, ties remote power control into the room controller, and integrates it as part of a coherent audio chain.
The AMP-2210T is Crestron's 2-channel commercial power amplifier, driving speakers in meeting rooms, boardrooms and conference spaces where clean, reliable level matters.
It delivers 210W per channel at 4 ohm and switches between 4/8 ohm low-impedance and 70/100V constant-voltage loads via terminal block, so it suits either local room speakers or distributed ceiling lines. Per-channel remote power control and auto power-down after 30 minutes of no signal cut idle draw to under 1 W standby.
Its fanless, convection-cooled 1RU chassis runs silently in a rack near sensitive microphones. AVSTEK matches it to speaker loads, ties remote power control into the room controller, and integrates it as part of a coherent audio chain.
Single-space 1U rack mountable power amplifier
Ultra-efficient space-saving design
Low total cost of ownership
High-output power, low noise, low distortion performance
Each channel selectable for 4/8Ω, 70V, or 100V operation
Two channels each rated 210W@4Ω, 120W@8Ω, and 120W@70/100V
Transformer isolated 70 and 100 Volt outputs
Bridgeable for 420W@8Ω
Individual channel power control via jumper or remote contact
Auto power-down after 30 minutes of no signal
Instant auto power-on when an input signal is detected
No inrush current during power-up
Over current and DC offset protection per output
Thermal protection on the power supply and each channel
Front panel signal, clip, and fault indicators per channel
Professional balanced inputs
Detachable terminal block connectors
Rear panel ±10dB input level controls
Convection cooled - no noisy fans
Under 15 inches deep
Universal power supply with active power factor correction